Sandy Springs, GA has turned to Comfort Control since 1992 for professional cooling and heating repairs, installations and maintenance.
Check out these reviews and see how we deliver air conditioning and heating service that residents of Sandy Springs, GA turn to us for again and again.
Local Reviews
for Sandy Springs, GA
james@comfortcontrolinc.com
A/c diagnostic in sandy springs.
Jordan R.
Heating maintenance in sandy springs. 1 system heat check. All components tested within normal manufacturing spec. System is heating normally at this time. Suggest compressor saver to reduce stress on compressor and reduce energy consumption on start up which will extend the life of the system.
Ta K.
Complete 1 system a/c repair and preventative maintenance check. Replaced filter, checked electrical and safety switches all ok at this time. Found bacteria/mold growth on evaporators coil and blower compartment. Needs evaporator coil cleaning/blower compartment area and uv light system. The system is cooling normally. The bedroom on the right is colder the. The rest of the home tested the temperature of the ceiling and it was 5 degrees colder than the rest of the ceiling. Room temperature is about 4 degrees colder.
Ta K.
Complete 1 system furnace repair and preventative maintenance check. Replaced filter, checked electrical and safety switches all ok at this time. Suggest uv light for bacteria and mold prevention. The overall system is heating normally.
Ta K.
1 system A/C renewal. Replaced filter, cleared drain and clean condenser coil. The system is cooling normally
Ta K.
1 system furnace repair and preventative maintenance check Replaced filter, checked electrical and safety switches all ok at this time. Suggest adding Apco UV light for bacteria and mold prevention. Replaced blower starter, tested and the system is heating normally.
Ta K.
1 system cooling early bird special. Replaced filter. Found mold and rust inside air handler. Found weak blower motor controller and burnt/ pitted main switch. Owner wants to wait. System is cooling at this time.
Ta K.
Zone 3. 1 system heating prepaid pm. Left filter for owner, checked electrical and safety switches all ok at this time. Replaced voltage absorption for heatpump. Needs uv light to kill the mold inside evaporator coil. Suggest to add surge protector for heatpump system. System is heating normal at this time